Golden-lighting 1264-3P PW Manuel d'utilisateur télécharger pdf (Page 2)

For Customer Service, contact the place of purchase to arrange for replacement parts.

4. By measuring determine correct number of links

needed for proper hanging height. Use a pair of

pliers to open one link of the Chain (C2) then

remove the excess Chain (C2) and discard it.

5. Use one chain connector (E2) to attach one end

of the chain to the Top loop (D2) and close the

chain connector.

6. Feed the fixture wires through the Chain (every

three links) and pull the wires until taut.

7. Slip Canopy loop collar (B2) over the chain, then

do the same with the canopy (F2).

8. When ready to complete the installation Use the

other chain connector and attach the other end of

the chain to the canopy loop (A2) and close the

chain connector.

9. Make sure the weight of the chandelier is

supported b

the chain-not the electrical wire.

* You may now install the fixture.

Fig 2

PARTS & ASSEMBLY SHEET

Fixture Name: Grace 1264-3P PW / RBZ

NOTE: Finish installing the glass after the fixture is hung.

10. Thread the Nipple (F) into the Socket assembly (E),

lock into position by the tightening hex nut.

11. Install the light bulbs in accordance with the fixture’s

specifications.

12. Slide the Spacer (H), Glass shade (G), Rubber

washer (I), Metal washer (J) over the Nipple (F) secure

them by the Hex Nut (K).

13. Slide the Bottom Cap (L) over the Nipple (F), screw

the Finial (M) onto the Nipple (F) until tight.

(DO NOT EXCEED THE MAXIMUM WATTAGE RATING)

Fig 3

1 2 3

Pas de commentaire

Golden-lighting 1264-3P PW Manuel d'utilisateur Page 2