Golden-lighting 8106-6 CDB Manuel d'utilisateur Page 2

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 3
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 1
PARTS & ASSEMBLY SHEET
Fixture Name: Torbellino 8106-6 CDB
Note: Complete these remaining steps after the fixture is
hung.
14. Place the Glass Shade (P) over the Threaded Socket
(O),place the Socket washer (Q) over the threaded
socket (O) then secure the Glass Shade (P) by threading
by the Socket Ring (R) until tight.
15. Install the light bulbs in accordance with the fixture's
specifications.
(DO NOT EXCEED THE MAXIMUM WATTAGE RATING)
Fig 4
For Customer Service, contact the place of purchase to arrange for replacement parts.
8. By measuring determine correct number of links
needed for proper hanging height. Use a pair of pliers to
open one link of the Chain (C2) then remove the excess
Chain (C2) and discard it.
9. Use one chain connector(E2) to attach one end of the
chain to the Top loop (D2) and close the chain connector.
10. Feed the fixture wires through the Chain (every three
links) and pull the wires until taut.
11. Slip Canopy loop collar (B2) over the chain, then do
the same with the canopy (F2).
12. When ready to complete the installation Use the other
chain connector and attach the other end of the chain to
the canopy loop (A2) and close the chain connector.
13. Make sure the weight of the chandelier is supported
by the chain-not the electrical wire.
* You may now install the fixture..
Fig 3
3. Unscrew four of the Deco screws (L) from the Frame
(K) and save.
4. Two arms are already attached to the Frame. Gently
spread the remaining four arms until evenly spaced.
5. Align the hole in lower side of Frame arm (K) with hole
Frame(K). Secure in place with the Deco screw (L).
6. Repeat with remaining arms and Deco screws.
* NOTE: The Finial can be scratched or broken if the full
weight of the fixture is placed on it. To avoid damage
attach Finial after hanging the fixture.
7. Attach Finial (N) to the base of fixture Frame (K) by
threading the Finia l(N) onto the threaded rod (M) until
tight
Fig 2
B2
A2
C2
E2
D2
E2
Q
R
P
O
Q
R
P
O
K
M
N
L
J
Vue de la page 1
1 2 3

Commentaires sur ces manuels

Pas de commentaire