Golden-lighting 8981-3P GRM Manuel d'utilisateur télécharger pdf (Page 2)

Note: Complete these remaining steps after the fixture is

hung.

12. Secure threaded nipple (P) to bushing (M) of housing

and screw Hex nut (N) on to secure.

13. Place Bottom cap (O) over the Threade nipple (P).

14. Screw Finial (Q) to threaded nipple (P).

15. Install the light bulbs in accordance with the fixture's

specifications.

(DO NOT EXCEED MAXIMUM WATTAGE RATING)

Fig 4

* NOTE: The Finial can be scratched or broken if the full

weight of the fixture is placed on it. To avoid damage attach

the Bottom Assembly parts after hanging the fixture.

4. Slide the center support of the fabric shade over center

tube to the housing, it is open on one side for ease of

assembly. Secure in place by tightening Cap nut (J) to

Frame (K) with frame of shade between them (I).

5. Attach 3 crystal draping chain (G) to hook (H) of shade.

Fig 2

For Customer Service, contact the place of purchase to arrange for replacement parts.

6. By measuring determine correct number of links needed

for proper hanging height. Use a pair of pliers to open one

link of the Chain (A2) then remove the excess Chain (A2)

and discard it.

7. Use one chain connector(A12) to attach one end of the

chain to the Top loop (A) and close the chain connector.

8. Feed the fixture wires through the Chain (every three

links) and pull the wires until taut.

9. Slip Canopy loop collar (A11) over the chain, then do the

same with the canopy .

10. When ready to complete the installation Use the other

chain connector and attach the other end of the chain to the

canopy loop (A10) and close the chain connector.

11. Make sure the weight of the chandelier is supported by

the chain-not the electrical wire.

* You may now install the fixture.

Fig 3

PARTS & ASSEMBLY SHEET

Fixture Name: Echelon 8981-3P BRI / GRM

1 2 3 4 5

Pas de commentaire

Golden-lighting 8981-3P GRM Manuel d'utilisateur Page 2